Craftin' across the miles: Moonlight Mittens

So I made these mittens last year by improvising a pattern. I wrote down what i did, and today Joelle asked me for the pattern. After a few hours worth of tweaking, I completed my very first original pattern! Exciting! If you don't remember these, I talked about them here and here.

Moonlight Mittens!

Pattern by Molly Wick

Yarn: Natuasha Handknits Creative Focus Worsted, 1 skein
Needles: size 6 double pointed needles

Ribbing:
CO 36 st on no. 6 dpns. Join for knitting in the round
*(K1, P1) Repeat until ribbing measures 7 cm.

Mitten Increases:

Row 1: Knit
Row 2: Increase 1. Place marker. Knit to last st. Place marker before last stitch. Inc 1. The increase stitches between the two stitch markers will become the thumb for the mitten.
Rows 3: Inc 1. Knit cable chart* to last st. Inc 1.
Row 4-15: Inc 1. Knit as shown in cable chart. Inc 1.
Row 16: Put first 14 st on st holder. K37 (to st marker). Put remaining 13 st on st holder. The stitches on the stitch holder will form the thumb.

Mitten Body: 36 st on needles.
Row 17 and up: Knit cable repeat (in chart) until mitten measures 22cm from bottom of cuff. (cable on every fifth row)

Mitten Decreases:
Start these when mitten measures 22cm. Start with 36 st.
Row 1: k2tog, k15, ssk, k2tog, k15, ssk. This should finish round.
Row 2: k2tog, k13, ssk, k2tog, k13, ssk
Row 3: k2tog, k11, ssk, k2tog, k11, ssk
Row 4: k2tog, k9, ssk, k2tog, k9, ssk
Row 5: k2tog, k7, ssk, k2tog, k7, ssk
Row 6: k2tog, k5, ssk, k2tog, k5, ssk
Row 7: Put remaining st on two dpns, the front on one dpn and the back on another. Use third needle to knit into first two st on each needle, and bind off the two sides together to close the end.

Mitten Thumb:
Pick up 26 st on dpns from st holder.
Row 1: k12, inc, inc, k12. 28st.
Row 2: k2tog, k11, inc, inc, k11, ssk.
Row 3: k2tog, k24 ssk.
Row 4: k2tog, k8, sssk (slip 3 & knit), k3tog, k8, ssk.
Row 5: k2tog, k6, ssk, k2tog, k6, ssk.
Row 6: k2tog, k4, ssk, k2tog, k4, ssk.
Row 7: Cut working end and thread it through remaining st. Knot on inside of thumb.

Weave in all ends. Block if desired (suggested) and enjoy!

*To cable: place first 2 "x" stitches (from cable chart) on cable needle and place these behind or in front of knitting, according to chart. Knit next two stitches. Knit two stitches off of cable needle, and continue in pattern. The cable pattern calls for three cables across the back of the mitten, so you repeat the cable three times. The middle cable has a “worm” form, from alternating where the held cable stitches are placed ( in front or in back of work) while knitting other two stitches.

Cable Charts